Differences

This shows you the differences between two versions of the page.

--- unixsurplus:dental_x-ray [2014/09/15 01:41] – mcmaster
+++ unixsurplus:dental_x-ray [2015/11/25 05:20] (current) – removed mcmaster
@@ Line 1: / Line 1: @@
-Info I've collected on the dental x-ray sensors that I got from UNIXSurplus at DEFCON 22.  These supposedly use USB.  Manufacturer or any other details unknown.
-WARNING WARNING WARNING
-Bond wires are exposed!  Be very very careful handing these!
-WARNING WARNING WARNING
-JM inventory:
-  * Unit: bond wires partially covered in glue.  Wires in perfect condition / intact
-  * Unit: bond wires ruffled but looks okay
-  * Unit: bond wires overall in good condition.  HOWEVER, a small section was ruffled and a wire broke (PCB side).  As they are aluminum I don't know if I can solder it
-  * Unit: bond wires in good condition.  No scintilator (and it looks like it never had one: no glue marks etc)
-  * Unit: in overall very poor condition.  No bond wires.  PCB has severe damage.  Sensor has severe damage.  Scintilator is damaged and separated from sensor
-====== USB interface ======
-TODO: solder wires to USB port and/or order cable
-====== PCB ======
-===== Flash =====
-"128 Megabit CMOS 3.0 Volt Flash Memory with 104-MHz SPI (Serial Peripheral Interface) Bus"
-  SPANSION
-  FL128PIF
-  12699003 C
-  THAILAND
-  (C) 06
-===== FPGA =====
-Sticker:
--
-Package:
-  Actel
-  ProASIC3
-  A3P250
-  QNG132 1140
-  ZA637115
-===== FX2 USB controller =====
-"CY7C68 Series 16 kb RAM EZ-USB FX2LP USB Microcontroller"
-  CY7C68
-A4S65
-===== 274 =====
-  .VY
-====== Die ======
-No maker's mark observed on die.  There are some foundry marks but that probably won't be very helpful even if the foundry is identified